I am now a one gun hunter.

[Moosetalker]

Originally Posted by stonefish

I like the 168 TSX at 2,925 fps for everything.

I can second this motion Both a Remington 30-06 and my SIL Savage 30-06 Plus in my Remington 300Wm all get sub MOA groups

If there's a downside its bullet recovery only managed 2 out of 10 critters. 1 moose Frontal shot 90 yds found in rear of paunch 3 steps and down. 1 WT 160 yds Frontal entry right of neck found at base of left side of tail. all others from 20 yds to 450 yds were pass thru. Non traveled further than 50 yds after shot.
I got a supply of 168TTSX looking forwards to getting them to go sub MOA

[bcpappy]

180 accubond is what I run in my 30-06 as an all around gun, as a one gun hunter I wouldn't change it as this load shoots well. I have tried 165 accubonds and they group good but don't not as tight. Next try would be 150 ttsx.

[Forhunt]

I have a semi custom 300 wsm, that came with a ragged hole 3/8" group target and the load that did it. I don't reload. The federal premium 180 accubond, won first place from the few I tried a couple paper shots with. Accurate, good stability at longer ranges, and they punch pretty hard too. Deer to elk, and moose have all been fine with it.