Went to the range yesterday to check the zero on my coyote rifle. First shot was about 2 inches high and right. Next shot I could not see, fired another nothing, thinking they must be in the black, fired another to get a group and then went and checked my target printed of a 7X11 sheet. Nothing, never hit the paper again.
Went back to the bench and dug out a large target from the garbage can. Stapled it up and then put my smaller target over the holes in the large paper. Fired 4 more shots, my group is about 8 inches.
This rifle is a consistent 3/4" group rifle, so took it home and took the scope off today. All the screws were tight on the mount as well as the base, the action screws were tight. I have never had a scope fail, but cannot see what else it could be? I mounted another scope just now and will hit the range in the AM.
Is there anything else I should be considering?
Scope Failure?
Threaded Mode
