I've heard the string stop on the Triax may be glued in as well as having
allen lock down screws. So I made a simple tool to check the bottom
cam lean out of some aluminum square tubing I had laying around.
If you make one be sure to remove any rough edges at the cut ends
so as not to mark or cut into your cam or string/cables.
Tool on bench with steel streight edge laying against it's bottom edge.
Side view of tool
View of string stop clearance
View of tool in use on bottom cam to nock point
View of arrow layed on top cam to nock point
Speeds along tuning when changing top hats or cam spacers.