ISO - 1pc floor plate for Winchester Model 70 Short Action

[jayquiver]

Looking for one in either blued or stainless. Would consider buying a used one or a new one.

As far as new, I found Pacific Tool and Gauge and Sunny Hill make them.

Any other companies make what I am looking for? Or any sources for a used one?

Thanks

[kujoseto]

Have you checked with Western Gun Parts in Edmonton?

[Pathfinder76]

Originally Posted by jayquiver

Looking for one in either blued or stainless. Would consider buying a used one or a new one.

As far as new, I found Pacific Tool and Gauge and Sunny Hill make them.

Any other companies make what I am looking for? Or any sources for a used one?

Thanks

Those are about it. One is by and large junk and the other quite expensive. Swift does make Blackburn units, but I’m not sure about SA ones and I’m a little more than suspicious of their quality as well.

[Pathfinder76]

Originally Posted by kujoseto

Have you checked with Western Gun Parts in Edmonton?

They would be an OEM option only and be prepared to spend a lot of money and wait.

[jayquiver]

Originally Posted by chuck

Those are about it. One is by and large junk and the other quite expensive. Swift does make Blackburn units, but I’m not sure about SA ones and I’m a little more than suspicious of their quality as well.

I am assuming the Sunny Hill are the expensive ones?

Are they much better than the factory options or just lighter?

[Pathfinder76]

If they are aluminum they will be lighter. They will be quite a bit nicer and more refined. But I don’t think they will fit the factory bottom metal inlet.