Quote:
Originally Posted by KBF
This I am interested in. Find on YouTube perhaps or do you have a link?
|
I did mine years ago and at that time I did a post on a atv forum but I think it’s since been removed. Not sure if there are any videos of others doing the same mod. I can try find you a link.
U can buy the same fuel pump I used from princess auto it’s a 12v posi flow fuel pump that runs about 3-5 psi any more and it’ll push past the float needle and seat
First you’ll need to take the plastic tray with all your electronics on it out so u can see the fuel tank and pump and valve. Remove your fuel pump by paying attention to what lines go where because all you will need is fuel line to carbs and fuel line from tank valve. The valve that is on top of tank will have a prime and on position you’ll need to turn that to prime. Now plug off the one fitting that a vacuum line went to on that valve and the fuel out to fuel pump is the one you will put into your new pump I put my new pump upside down where the old one was, And the other end gets the line that goes to carbs. (Sorry if that’s sounds too obvious) now that you won’t need the vacuum lines coming from heads u can cut them shorter and plug them together with a vacuum line connector it’ll work as a mini crossover or u can just put vacuum plugs right into the head ports.
For fuel pump electrical hook 12v to key on power and ground straight to battery.
The way that my fuel pump lays in under the electrical tray upside down it works out I put heavy foam weather stripping on top and bottom of it and put tray back in place.
Turning your valve on top of tank from on position to prime is crucial for the electric fuel pump install.
By far the best thing that ever happened to my brute
If any of that is unclear you can pm me not sure if this is the place for write ups like this.