|
|
11-11-2019, 01:26 PM
|
|
|
Join Date: Aug 2015
Location: Alberta
Posts: 1,269
|
|
Quote:
Originally Posted by barbless
Stop putting your over sweated grain dusted hats from the field and the engine parts you want cleaned in it. Oh you didn't know about cleaning engine parts in the dishwasher? Not good for the washer but cleans em good. I know a few people that work on rebuilding and race and they have one in their garage as well as a varsol parts cleaner.
|
So........ do they use vinegar and CLR to keep their garage dishwashers running smoothly ?? 😂
|
11-11-2019, 01:56 PM
|
|
|
Join Date: Sep 2008
Location: NW Calgary
Posts: 2,785
|
|
Quote:
Originally Posted by 270person
Sure it will. If you've got time to run 6 cycles and dump in a gallon per. Simple science says a pH of 4+ will barely dissolve a pinch of powdered baking soda. Its barely acidic and an acid base is required to dissolve calcium, lime, and other hard water caused scaling effectively. pH of 2 minimum is required and even that's going to take a good while to work.
Every factor of 10 increases or decreases a solution pH by 1. Household vinegar has a pH of roughly 2.5. Dilute 1:10, it's now 3.5. Dilute 1:100 as you're suggesting takes it to 4.5. That's a fart in a hurricane.
If one insists on using an anemic acidic at least go with citric. Its not going to dissolve anywhere near all but it beats vinegar and doesn't reek when heated. Either would be ok to clean minor filming off glassware but if there's a decent buildup in the dishwashers internals, as is usually the case, it won't make a difference at the dilution and qty's suggested.
CLR is weak sauce since they changed to formula and went away from phos acid to lactic. We can agree it should not be used simply because it's not much more effective than vinegar.
As far as appliance repair guys are concerned, most of us like to see them less rather than often, so I understand your reasoning.
|
What about using a concentrated vinegar (25%) and adding high heat?
|
11-11-2019, 02:03 PM
|
|
|
Join Date: Nov 2016
Location: Edmonton
Posts: 6,496
|
|
Quote:
Originally Posted by reddeerguy2015
Well an update. Ran vinegar. AND CLR. 😲 (Google said I could...).
Anyways. It looks just like it did yesterday. Except now I got a warm fuzzy feeling inside - so it must have done something.
Results will vary.
|
Maytag man job if work gets dicey? Warm fuzzies are good.
__________________
You matter. Unless you multiply yourself by the speed of light squared... ...then you energy.
|
11-11-2019, 02:07 PM
|
|
|
Join Date: Nov 2016
Location: Edmonton
Posts: 6,496
|
|
Quote:
Originally Posted by AndrewM
What about using a concentrated vinegar (25%) and adding high heat?
|
I only know of 12% and it's not the type you should put on your fish and chips. You'd use less of it, 1/2, and 1/4 of the 25% if you can find it.
Heat definitely activates chloride acids. Don't have enough experience with vinegar to say y or n.
__________________
You matter. Unless you multiply yourself by the speed of light squared... ...then you energy.
|
11-11-2019, 03:39 PM
|
|
|
Join Date: Sep 2008
Location: NW Calgary
Posts: 2,785
|
|
Quote:
Originally Posted by 270person
I only know of 12% and it's not the type you should put on your fish and chips. You'd use less of it, 1/2, and 1/4 of the 25% if you can find it.
Heat definitely activates chloride acids. Don't have enough experience with vinegar to say y or n.
|
I think you can get it at most asian supermarkets. But if you the same volume as you would the 5% and add a pile of heat you may get the reaction you require to dissolve the scale. 5% works well in my kettle to clean the element. But I agree with you, other acids may be more suitable.
Last edited by AndrewM; 11-11-2019 at 03:51 PM.
|
11-11-2019, 04:14 PM
|
|
|
|
Join Date: Nov 2010
Location: Alberta
Posts: 1,028
|
|
Dishwasher problem
The wife ok?
|
11-11-2019, 05:04 PM
|
|
|
|
Join Date: Jan 2014
Location: Edmonton
Posts: 5,612
|
|
Quote:
Originally Posted by 270person
Sure it will. If you've got time to run 6 cycles and dump in a gallon per. Simple science says a pH of 4+ will barely dissolve a pinch of powdered baking soda. Its barely acidic and an acid base is required to dissolve calcium, lime, and other hard water caused scaling effectively. pH of 2 minimum is required and even that's going to take a good while to work.
Every factor of 10 increases or decreases a solution pH by 1. Household vinegar has a pH of roughly 2.5. Dilute 1:10, it's now 3.5. Dilute 1:100 as you're suggesting takes it to 4.5. That's a fart in a hurricane.
If one insists on using an anemic acidic at least go with citric. Its not going to dissolve anywhere near all but it beats vinegar and doesn't reek when heated. Either would be ok to clean minor filming off glassware but if there's a decent buildup in the dishwashers internals, as is usually the case, it won't make a difference at the dilution and qty's suggested.
CLR is weak sauce since they changed to formula and went away from phos acid to lactic. We can agree it should not be used simply because it's not much more effective than vinegar.
As far as appliance repair guys are concerned, most of us like to see them less rather than often, so I understand your reasoning.
|
Listen, I’m not a chemist and am not going into the analyzing the formulas etc, all I’m saying that this trick with vinegar works! I don’t understand why are you keep arguing/questioning this. Try it once, thank me later. Or don’t, I really don’t care. Been recommending customers that for the past 20 years and not a single person told me it didn’t clean his dw. It’s just the way it is!
|
11-11-2019, 06:01 PM
|
|
|
Join Date: Sep 2008
Location: NW Calgary
Posts: 2,785
|
|
Quote:
Originally Posted by KGB
Listen, I’m not a chemist and am not going into the analyzing the formulas etc, all I’m saying that this trick with vinegar works! I don’t understand why are you keep arguing/questioning this. Try it once, thank me later. Or don’t, I really don’t care. Been recommending customers that for the past 20 years and not a single person told me it didn’t clean his dw. It’s just the way it is!
|
Lemi shine should work as well. Easy to store powder that doesn’t take up much space. Supposed to help with scale in dishwashers.
|
11-11-2019, 06:33 PM
|
|
|
Join Date: Oct 2008
Location: High River
Posts: 173
|
|
Vinegar
We have been using vinegar in our dishwasher for years. Hard water in town. Put a half cup in with every load. Buy in bulk from Costco. It works
|
11-11-2019, 09:18 PM
|
|
|
Join Date: Nov 2016
Location: Edmonton
Posts: 6,496
|
|
Quote:
Originally Posted by AndrewM
Lemi shine should work as well. Easy to store powder that doesn’t take up much space. Supposed to help with scale in dishwashers.
|
It's citric acid which I mentioned earlier. A bit weaker than vinegar. If you like it you could likely save $$ buying it in its normal form vs paying for the brand name.
__________________
You matter. Unless you multiply yourself by the speed of light squared... ...then you energy.
|
11-11-2019, 10:31 PM
|
|
|
Join Date: Sep 2008
Location: NW Calgary
Posts: 2,785
|
|
Quote:
Originally Posted by 270person
It's citric acid which I mentioned earlier. A bit weaker than vinegar. If you like it you could likely save $$ buying it in its normal form vs paying for the brand name.
|
Thank you for the info. I was well aware of that but wanted to point out an option that every Canadian tire has and is easy to find. Only use I need of Lemishine is to clean my brass while tumbling. Works amazing.
|
11-12-2019, 09:17 AM
|
|
|
Join Date: Oct 2014
Location: NW Alberta ....
Posts: 659
|
|
Laugh if you want but Tang orange juice crystals work like a hot damn to clean up dishwashers.
__________________
Who is John Galt?
|
11-12-2019, 10:41 PM
|
|
|
Join Date: Apr 2014
Posts: 221
|
|
Well I think it leaked tonight, test it out again tomorrow so it may be a moot point. Thanks for all the tips people!
|
11-13-2019, 03:28 PM
|
|
|
Join Date: Apr 2008
Location: calgary ab
Posts: 2,703
|
|
Quote:
Originally Posted by reddeerguy2015
So........ do they use vinegar and CLR to keep their garage dishwashers running smoothly ??
|
I will ask, it was brought up about two weeks ago but they say it works. Go figure. Nothing like a nice warm wash and a heated dry after a varsol bath.
|
11-14-2019, 09:01 AM
|
|
|
|
Join Date: Jul 2016
Posts: 3,413
|
|
Repair or buy new?
Were you able to identify the source of the leak? Was the leak clean water or soapy water?
If it was clean water near the front, the water inlet valve is the most common point of failure. It is relatively inexpensive and easy to change on most models. Don't forget the teflon tape on threaded fittings.
Soapy water near the middle? Unless it is a leaking hose, the repair gets more complicated, and the parts are more expensive. Decide how much you are willing to invest in a 8-9 year old appliance before you get too far into it.
Amre Supply and Reliable Parts are good sources for replacement parts.
https://www.amresupply.com/catalog/D...r-Parts-632542
https://www.reliableparts.ca/catalog/474959
__________________
“One of the sad signs of our times is that we have demonized those who produce, subsidized those who refuse to produce, and canonized those who complain.” - Thomas Sowell
“We seem to be getting closer and closer to a situation where nobody is responsible for what they did but we are all responsible for what somebody else did.”- Thomas Sowell
|
11-14-2019, 09:31 AM
|
|
Moderator
|
|
Join Date: Jul 2008
Location: A bit North o' Center...
Posts: 11,150
|
|
I Agree with Urban Rednek.
|
11-16-2019, 03:19 PM
|
|
|
Join Date: Apr 2014
Posts: 221
|
|
Thanks for the patience, a house full of family for a week and today I checked all the items that were suggested and everything looks fine. The "leak" turned out to be someone opening it while it was running. My electrician uncle came up with the simplest suggestion...flip the breaker off for a couple of minutes...of course that may only work temporarily but it has kept me from having to cancel the cycle repeatedly and restart. I can delay buying new one for now.
Thanks everyone, I really appreciate it!
Scott
|
11-17-2019, 10:48 AM
|
|
|
Join Date: Dec 2009
Posts: 1,309
|
|
Did you clean the water sensor at the bottom of the tray like I described earlier or does it not have one?
|
11-17-2019, 11:48 AM
|
|
|
Join Date: Aug 2008
Location: Vancouver Island ,BC
Posts: 714
|
|
Try the old fashioned way, use the sink.
|
11-17-2019, 12:14 PM
|
|
|
Join Date: Jan 2010
Location: Calgary
Posts: 4,340
|
|
Quote:
Originally Posted by KGB
Here is the best Maintanance tip you will ever have for the dishwasher: once a month empty your dw, take a large coffee mug and fill it with the regular white vinegar to the 3/4 and place it on the top rack. Turn the dw on the heavy duty cycle with the hottest temp settings. Let it run thru the cycle.
It dispenses the vinegar slowly cleaning all internal parts including the pump, valves and filters etc etc etc. It removes all hard water build ups and all soap residue. It is not toxic and the dw can be used right after that without additional flushing/cleaning.
|
x2 but i use 2 cups of vinegar...LOL....
Been good for almost 10 years now. Replaced the chopper a few months back as well which prevented the top rack from getting cleaned.
|
11-17-2019, 06:47 PM
|
|
|
Join Date: Apr 2014
Posts: 221
|
|
Quote:
Originally Posted by propliner
Did you clean the water sensor at the bottom of the tray like I described earlier or does it not have one?
|
No H2O sensor in this model.
|
11-17-2019, 06:49 PM
|
|
|
Join Date: Apr 2014
Posts: 221
|
|
Quote:
Originally Posted by 303carbine
Try the old fashioned way, use the sink.
|
When its just me at home that's what happens, but with a house full of guests, or when three daughters, GF and her daughter rotate through, mechanized assistance is the way I roll.
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -6. The time now is 05:23 AM.
|