Polaris bushings for front "A" arms

[TBark]

Was having some clunking in the front end of my 2010 XP EPS 850 Polaris.
I put it up on blocks, pulled front wheels and both L&R lower A arm bushings have a lot of slop.
I greased them up and it took up some slop but after another week or so of riding, the grease worked it way out and its loose again.
The bushings are hard polly, obviously wearing, not sure if this is the best material for a bushing.
Anyone know if there are any replacement bushings of better material for my quad ?

TBark

[B-radshaw]

jccapri bushings all the way. You may have to buy an entire kit to do your whole bike but it will most likely be the last time you replace them. It cost me about 250 to do my whole bike but havnt looked back since and that has been 7 years ago with plenty of hard riding since then.

[797truck]

Another option is DK offroad, he is located here in Edmonton (I believe). A number of our group have been running these for a few years, with good results.
He has an ad listed on Kijiji, just do a search for him.
His contact information is DK OFFROAD 780 238 3684. Dkoffroad@shaw

[blgoodbrand1]

Just a note to be sure and replace the tubes(inside the bushing) at the same time.
I'll be looking into these aftermarket ones too


Sent from my iPhone using Tapatalk

[TBark]

Good info folks, thanks.

TBark