Quote:
Originally Posted by 45-90scout
Perfect. Thanks. Will try that tomorrow
|
Carefull not to overheat...will destroy a shaft in seconds if done...
I also use this method...dont seat the tip all the way and let heat transfer down point threads...have patience let heat be gradual...while pulling on arrow...
Another method is pull nock drop a drill in backwards exact size of shaft and hold shaft up so bit sits in nock area give the shaft a swing in safe area and at times insert pops right out pending on glue...havent damaged one shaft this way...insert are garbage after of course...
I use a 30 Cal rifle bore metal brush on a handle ...dipped in Acetone ...clean like rifle barrel ...a folded pipe cleaner or Q-tip finishs the job
Neil