Either is fine, but I'd recommend using a lineset as indicated above. Your supplier will be able to size it for you, based on length and number of elbows used. Another advantage to the lineset is that it will come pre-insulated. Take care making your bends, takes surprisingly little to kink a line. And also noted, you can't simply solder and A/C line. Had to be a brazed joint, using silfos. So you'll need a torch capable of getting the copper to the 1500 degree range. Also be sure to protect your service valves and TXV or oriface.
Or, might be a good idea to hire a proffesional. . . Just sayin
__________________
You bet your ass I voted
|