|
08-18-2017, 12:59 PM
|
|
|
Join Date: Aug 2017
Posts: 2
|
|
Tikka T3x 3006
Just purchased myself a new tikka T3X 3006, what yards do you use run your sight at generally? Running 180g bullets, curious what others are doing. Also do you guys reccomend just buying your accessories straight from tikka or is there a good website to use?
|
08-18-2017, 01:18 PM
|
|
|
|
Join Date: Dec 2010
Location: My House
Posts: 13,458
|
|
If you are a normal hunter, not a long range commando like so many seem to be these days, zero your gun at two hundred and go hunting. Good luck. Shoot at 100 and 300 and you are money.
|
08-18-2017, 01:47 PM
|
|
|
Join Date: Jul 2016
Location: Edmonton
Posts: 146
|
|
I agree with SNS. That's how I have my 30-06 set up as well.
Most of my shots are inside of 200 yards which means it'll hit right on the cross hairs or a tiny bit high. I don't adjust for it. Anything out to about 300 yards should be about 6 to 8 inches low. If you're aiming behind the shoulder or somewhere very close to that you'll still be in the vitals or very near even if you're cross hairs are set to behind the shoulder. I aim at just below spine for longer shots and never had a problem.
All depends on conditions and bullet too of course. This is assuming factory ammo and ideal conditions.
Congrats on the new rifle too!
|
08-18-2017, 02:55 PM
|
|
|
|
Join Date: Mar 2008
Location: Sylvan Lake
Posts: 3,419
|
|
May not be relevant but my Sako (same parent company and some claim the same barrels) is not especially fond of 180s and will only shoot a couple of types around an inch after a bunch of tinkering. It loves 165s and will shoot acceptable groups with most anything you stuff in it. It especially likes a fast boat tail like found in Superformance both the SSTs and GMX. It also shoots Hornady Interlock very well.
Anyway, I ended up wasting a fair amount of time and money trying to stuff a square peg in a round hole hoping I could get great results from 180s. With all the different bullets available there may be one in 165 or other that will shoot better, get the job done and get it done more efficiently than the 180s. You will most likely get a little flatter trajectory and less felt recoil as an added bonus.
I set my zero at 200 yards as well.
|
08-18-2017, 09:06 PM
|
|
|
Join Date: Aug 2017
Posts: 2
|
|
Great thanks guys! Will sight for 200 and buy myself a case of 165s!
|
11-08-2017, 08:21 AM
|
|
|
Join Date: Jan 2008
Posts: 4,329
|
|
T3x
My son just bought one in 30-06 and it is a 1/2" or better shooter.I loaded 150gr TTSX with 51gr of IMR 4895 seated 3.322" to fit the mag well with a little room.Chronied at 2949fps.The 165 Cor Lok's went in the same hole using 58gr/IMR 4831 not chronied.The 150's were sighted 2" high at 100 yards and centered the bullseye at 200 yards. I like the ergonomics of the new T3X a little better than the T3.
|
11-08-2017, 05:00 PM
|
|
|
Join Date: Nov 2016
Location: Quebec
Posts: 53
|
|
My 3006 shoot really well with Barnes TTSX 168 gr. Zero at 100 or 200 as you like
|
11-08-2017, 05:12 PM
|
|
|
Join Date: Jul 2016
Posts: 1,827
|
|
200 yards when I had the cross hairs only.
Now sighting in at 100 with my BDC retrical scope.
Those optics are a game changer.
Don
|
11-08-2017, 08:37 PM
|
|
|
Join Date: Dec 2014
Posts: 30
|
|
sighting in at 24 yards, gives me a shooting range of 50-300 yards with no holding over.
Of course this is not taking angles in consideration, and I always chrono my rounds since I hand load, factory loads gives you velocity on the box so it is easy to plug in those numbers in a ballistic calculator, free online btw.
But everyone is different its what works for you, I have a simple schmidt and bender scope so that makes it simple for me.
enjoy.
|
11-08-2017, 09:52 PM
|
|
|
Join Date: Jan 2013
Location: onoway, Ab
Posts: 6,982
|
|
Quote:
Originally Posted by glenn1911
sighting in at 24 yards, gives me a shooting range of 50-300 yards with no holding over.
Of course this is not taking angles in consideration, and I always chrono my rounds since I hand load, factory loads gives you velocity on the box so it is easy to plug in those numbers in a ballistic calculator, free online btw.
But everyone is different its what works for you, I have a simple schmidt and bender scope so that makes it simple for me.
enjoy.
|
Plugging in the advertised velocity into a ballistic app is just asking for a miss. Garbage data in garbage data out. I recently bought a box of nosler 270wsm 140 gr accubonds with an advertised velocity of 3100 fps. I bought this ammo to break in the barrel on a new 270wsm. I ran it across my magnetospeed and chrony. I got 2865 and 2840.
|
11-08-2017, 09:53 PM
|
|
|
|
Join Date: Mar 2009
Location: Medicine Hat
Posts: 3,219
|
|
Quote:
Originally Posted by glenn1911
sighting in at 24 yards, gives me a shooting range of 50-300 yards with no holding over.
|
Please elaborate
__________________
Participating in a gun buy back program because you think that criminals have too many guns is like having yourself castrated because you think your neighbors have too many kids...
|
11-08-2017, 09:59 PM
|
|
|
|
Join Date: Feb 2010
Location: Quesnel BC Canada
Posts: 5,599
|
|
Quote:
Originally Posted by lone wolf
Please elaborate
|
zero at 25 usually equates to dead on at 100.
|
11-08-2017, 10:26 PM
|
|
|
Join Date: Dec 2014
Posts: 30
|
|
Quote:
Originally Posted by lone wolf
Please elaborate
|
Well for me anyway, your mile may vary of course.
Since I hand load my rounds very carefully of course, I first chrono my cartridges, sight my rifle in at given range then go to shooterscalculator.com site and plug in the numbers, altitude weather etc., once I get a ballistic chart of where my rounds will hit at given distance I go back to the range and verify.
I carefully check my hits up to 300 yards, cause that is my max comfortable hunting range and make notes, having all that information gives me the confidence in my rifle and my ability to hunt up to but no further than 300 yards.
My whitetail this year was taken at a 6% angle according to my range finder at 210 yards, knowing that my rounds hit +/- 2.3" high with my loads I needed no adjustment shooting down on my deer, critter laid down in 10 seconds and expired, was very thankful to the deer gods of course.
But like any system, every one has one it is what works for the individual, some sight in at 100 and use a bdc turret or reticle, my schmidt is a simple 8x scope with a duplex reticle so no playing around with turret or bdc hold over, but then again it depends where you hunt; woods open field all that makes a difference in my approach.
|
11-09-2017, 07:47 AM
|
|
|
Join Date: Jan 2008
Posts: 4,329
|
|
me
I sight in at the range I'm shooting as mentioned velocities vary as speed sells and a chrony is a big help.Leupold's CDS is a winner.........Harold
|
12-04-2017, 03:43 PM
|
|
|
Join Date: Nov 2017
Posts: 175
|
|
3006
Last year I decided to put a nice scope on my Remington 3006. It was like my 80 year old grandma getting a boob job.
I wear glasses and I couldn't find anything in that scope for the life of me.
This year I bit the bullet and traded in on a Tikka T3 Lite.
I went old school and had a Williams peep sight mounted on it. No problem locating what I need to shoot.
|
12-04-2017, 04:23 PM
|
|
|
|
Join Date: Aug 2009
Location: Oz
Posts: 2,122
|
|
Quote:
Originally Posted by operator john
Last year I decided to put a nice scope on my Remington 3006. It was like my 80 year old grandma getting a boob job.
I wear glasses and I couldn't find anything in that scope for the life of me.
This year I bit the bullet and traded in on a Tikka T3 Lite.
I went old school and had a Williams peep sight mounted on it. No problem locating what I need to shoot.
|
That's funny. Did you take the lens covers off?
I sight in 3" high at a hundred. The bullet being 3.5" above my line of sight at 150 yards doesn't bother me but it dropping an extra few inches at 350-400 yards does.
I usually run 165 accubonds so here's the difference between a 200 yard and a 270 yard zero.
|
12-04-2017, 05:13 PM
|
|
|
|
Join Date: May 2007
Location: WMU 303
Posts: 8,494
|
|
Quote:
Originally Posted by lone wolf
Please elaborate
|
Quote:
Originally Posted by CanuckShooter
zero at 25 usually equates to dead on at 100.
|
Example of 25 sight in and dead on at 150. Or as I would rather put it: Sight in at 150 and dead on at 25
|
12-05-2017, 03:47 PM
|
|
|
Join Date: Nov 2017
Posts: 175
|
|
3006
Quote:
Originally Posted by Coiloil37
That's funny. Did you take the lens covers off?
|
Now that's funny..
The peep sight doesn't need covers.
|
12-06-2017, 03:13 PM
|
|
|
Join Date: Nov 2017
Posts: 30
|
|
Tikka is a great rifle.. good choice!
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -6. The time now is 05:45 AM.
|