Go Back   Alberta Outdoorsmen Forum > Main Category > Guns & Ammo Discussion

Reply
 
Thread Tools Display Modes
  #1  
Old 04-02-2020, 08:49 PM
dth_ dth_ is offline
 
Join Date: Feb 2019
Posts: 56
Default Reloder 16 and the 6.5CM

Anyone have experience with going from H-4350 to Reloder 16 in the 6.5 Creedmoor? From what I gather they are similar powders. The burn rate is in the same vicinity with the RL-16 being a bit faster. Did your loads end up being in a similar ball park for charge weight and velocity? Was accuracy comparable to what most guys seem to see with H-4350?

I had great luck with 4350 and the 143 ELD-X at around 2750fps shooting under .5MOA. Looking at the load data from alliant, the RL-16 looks a bit quicker.
Reply With Quote
  #2  
Old 04-02-2020, 09:18 PM
chuck's Avatar
chuck chuck is offline
 
Join Date: May 2007
Posts: 12,429
Default

I’ve had great luck with RL 16 in the 6.5 Creedmoor. I’d have to check my notes to see how it compared to H4350.

RL 16 has been very consistent and out to 1000 yards has had negligible POI shift from 25 degrees to minus 25 degrees. I’m a fan.
__________________
“For the same reason that some top African PH's order rifles from D'Arcy Echols to use as loaners -- because we have to go in and clean up any messes they make.”
-Phil Shoemaker
Reply With Quote
  #3  
Old 04-04-2020, 03:27 PM
Roamer Roamer is online now
 
Join Date: Jan 2020
Posts: 53
Default

I have not used 4350 in my creedmoor’s, just RL16, and I really like it. I get 2760 from my 22” barrel and 2680 from my 20” barrel (both browning x bolts), I got 2700 from my 19” savage. I feel like the 20” is going to speed up a bit after some more firing. Both of my brownings like 41.3 grains in Hornady cases with federal 210m primers, I also shoot 143 eld-x bullets. Absolutely no signs of pressure. I didn’t even work up to pressure, just found the accuracy I like and stuck with it.

As noted by others, I also found very little change in velocity over a large temperature range.

Just don’t buy all of it.... leave some for the rest of us, haha!
Reply With Quote
  #4  
Old 04-06-2020, 09:41 AM
dth_ dth_ is offline
 
Join Date: Feb 2019
Posts: 56
Default

Thanks for the feed back on temperature stability. I managed to wrangle enough RL-16 to probably last close to the end of the barrels life.

Alliant data has 43.9gr under the 142gr SMK in a Hornady case, which sounds wayyy too hot for me. My Peterson brass has a bit less case capacity than the Hornady, so I think I've got a good comparison now of where to start.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 06:59 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.