I have just purchased a Forster neck turning attachment, mostly because I already had an Original Trimmer. The attachment and pilot mandrels were inexpensive (Grafs.com) and seem to work quite well. Some suggest that a lathe type turner is more stable and easier to keep true than a handheld unit, (I do not have enough experience for an informed opinion). I also purchased a power adapter, but have not yet used it other than checking for fit.
I did need to grind off a corner on the cutter head for clearance to the shoulder of a 300WM, I suspect you may also need to do this for your wildcat.
The feed and limit system installs between the cutter support bearing and the crank and reduces the range of case length that the unit can handle. As a trimmer I was using a 6.5” base for 308W to 338LM, but with the turner system installed, the 6.5” base was slightly too long for 06, but the 5.375” base works well for 08 & 06 brass.
Good Luck, YMMV
|