View Single Post
  #66  
Old 01-12-2012, 10:13 AM
Lefty-Canuck's Avatar
Lefty-Canuck Lefty-Canuck is offline
 
Join Date: Dec 2010
Location: Look behind you :)
Posts: 27,775
Default

Quote:
Originally Posted by urcayuse View Post
hi cat, I'm pretty new to re-loading,I've come up with a load i think works good in my rifle 46gn vrgt 165gn hdy sst case trim 2.005 coal 2.827 AV 2806 fps.....yell if any of this screams stupid....using nosler brass, probably on third firing,they extract fine no signs of over pressure that i can tell, but on my last batch the bolt was a little stiff to close could it be i've used too much lube and pushed in the shoulder? how do you tell? is it obvious? if i put one in the chamber then take it out even with out firing you can see marks on the case head wich i suspect may be from the extracter pin. any info or feed back would be very much appreciated
Are you full length sizing? Could need to set your die up a bit differently. Extracor marks on the case head are an indicator of pressure.

LC
__________________
Reply With Quote