Quote:
Originally Posted by 114239
Put a primed case in without bullet in and it wont work. Any help is appreciated
|
The “primed case without a bullet” was this a case you loaded, then pulled the bullet from when it wouldn’t chamber?
1)As a starting point I would take one of the loads that won’t chamber - pull the bullet, dump the powder, resize the case and see if it will chamber. This is just out of curiosity.
2)I would also dig through the cases you haven’t touched yet, find one that chambers easily. Now prime that case and see if it chambers. Again purely out of curiosity.
3)Resize your cases and try every one in your rifle, if it won’t chamber at that point it won’t after you load them. In my opinion it’s not a priming issue it’s either the cases aren’t resized properly or you’re bulging the shoulder when seating the bullet.