Quote:
Originally Posted by Dubious
We are going to try seating them Deeper to pull but I tryed that the other night and it made not much of a difference. We’re going to try full length resizing(as he always does) and annealing the brass I was looking for a crimp and didn’t see one it when I was over last night but will give a closer look when I go over again. He recently changed the expander ball on that die and I measured it measured .3065 it was a replacement from rcbs for an rcbs die. This is a head scratcher for sure I thought the table was going to break or the head/rim was going to fail we were putting a lot of pressure on it trying to pull them.
|
Just a question .. were the inside case necks cleaned with a metal brush just prior to bullet seating ?
__________________
When applied by competent people with the right intent, common sense goes a long way.
|