Quote:
Originally Posted by markg
My first problem with my new build. The 300 PRC seating die is very very tall. It wont fit in my press at COAL for seating the bullets.
I may have to buy a second press. I just dont have the room for it.
|
Looks like a relatively small interference problem a die grinder could fix.
If major material removal is required, then welding may be helpful to reinforce as necessary.
My Lee CC presses are missing a lot of powder-coat, but feel much nicer to the hand after de-horning, only the initial removal hurts.
Good Luck, YMMV.