got the timney installed in the Xbolt this morning
the Timney kit is about 1mm wider than the factory Browning trigger which has a recess all along both bottom sides to accommodate the safety bar. Took a few minutes to open up the carbon fibre for the extra width and was still sticking a bit so my wife suggested a tracing tape that she uses that leaves a blue chalk/powder when anything is pressed against it hard. Identified a high spot the safety ear was rubbing and it is all good. About 2 pounds (waiting for buddy with digital trigger pull scale) and nice and crisp. 200 % improvement on the factory original.
__________________
 a hunting we will go!!!!!!
|