View Single Post
  #5  
Old 08-14-2018, 06:30 AM
AlbertaAl AlbertaAl is offline
 
Join Date: Mar 2008
Location: Sherwood Park
Posts: 394
Default cleaning

I use a nylon brush with light lubricant to brush the inside of the neck before resizing. I usea a Hornady SONIC cleaner to clean my brass after it's been resized. This process removes the small amount of lubricant used in the resizing process along with carbon. I use an air compressor to blow residue moisture out of the brass and place the brass into the oven for a quick dry. Then it goes into the tumbler with crushed walnut for a polishing.

For a while, before filling my case with powder, I was dipping my necks into DRY GRAPHITE LUBE POWDER because I read that the Sonic cleaning process polishes the inside of the necks too much. For no reason, other then laziness have stopped doing this STEP.
Reply With Quote