[Bonescreek]

Update on the target range build..

I used horizontal catv cable siding clips attached to the marker post to hold them up from ground contact and 1 1/4" square plastic deck stile cut off in 6" lengths for a support anchor to be driven into the ground.

I routed out the numbers using an Old English font with my router.
That was the easy part, painting was Tedious Maxemus.

Also made a bench 3' wide by 24" high from the left over 12" wide lumber from
building the target frame. Put down a 4' x 5' area of pavers at 50 yards to set
the bench on, may build a gabaso around that come spring.

Managed to get the target filled and stuffed, is holding up very well but time
will tell. :-)

I realize hunting season is almost full tilt for you all been checking out your
pictures and reading your stories. Thanks for sharing.
I've still got about 3 weeks or so go before I'll be in the woods.
Best of luck to you all this fall. :-)