Framing of the overhang turns out to be a bit of a hangover.
But got it done ok.
3/4" plywood is down on the roof today and will be putting on the trim in the
morning. Then the tin goes up.
Note.. when using "used" mixed lumber, galvanized nails and stainless steel screws are the norm.
Some of the rafters are oak, all of the siding is treated pine deck boards, most
of the framing is clear pine in this building.
Standard rosin coated nails will rot away in a short time if used in treated wood.
Only use galvanized or stainless with treated lumber.