[Blockcaver]

The Tight Spot works well......but I did lose two arrows out of the #1 arrow gripper that is closest to the bowstring on remote backcountry hunts. I had adjusted the gripper slot(s) as tight as possible when I switched to Easton Injexion 330s (super skinny shafts). The cure for that was to fabricate a new wider wedge to go into the first slot. That tightened up the #1 hole and no issues since.

As a side note, I mentioned this to Tight Spot via email they mentioned the stock wedge can be rotated 90 degrees to achieve the same result as my custom wedge.........don't know, haven't tried it, but worth a look.

As per other quivers, I've forced round wood toothpicks, or slivers of PVC pipe into the rubber between the grippers to tighten them up. Also had somewhat satisfactory temporary results by adding Shoe Goo to the grippers. It doesn't last real well in my experience.

Good luck, hope you don't lose too many arrows!