Quote:
Originally Posted by DLab
Looked at this also to offset the cost of the AMP,had the owner of the LGS even run it by a few of the regular's to try to keep it local,as shipping took the process out of reasonable cost.It didn't seem like it would get much traction as far as regular run of the mill cases/cartridges are concerned.
Probably 20 % when asked about annealing went HUH? a WHAT?lol
Not enough serious target shooters in my area to make the initial cost/setup feasible,also figured the cost of a wet tumbling system into the setup,which in my opinion is also necessary.
I saw your previous post on the wet/pin system Chuck.
Decided I'll just stick to my 2 flame/torch set up,but that AMP is awfully tempting,just can't justify the cost for personal use.
|
I spoke with the owner of AMP regarding wet tumbling. He highly recommended against it. So that saves a few bucks. :-)