My steps
De prime fired brass
SS wet tumble
Dry in oven
Inspect each case and then sort into proper bin by head stamp and number of loads
Lube in a Tupperware with RCBS lube sprayed inside, just throw 20 brass in, a couple drops and then shake around.
FL size just enough to bump shoulder back 0.001”
Clean case with rag
Trim, chamfer, deburr
Neck size (I feel like I get a more consistent neck tension)
Hand Prime
Write the amount of powder on side of case with sharpie if doing a ladder test
Charge each case with RCBS chargemaster
Seat bullet while chargemaster is spitting out the next load
Caliper every few rounds with comparator to ensure consistent seat depth.
I usually do each step all at once so I don’t miss anything. Before seating the bullet I check each case for powder so I don’t have a squib at the range.
__________________
Trudeau and Biden sit to pee
|