View Single Post
  #15  
Old 02-10-2013, 07:37 PM
Hotwheels81's Avatar
Hotwheels81 Hotwheels81 is offline
 
Join Date: Jan 2012
Location: Valleyview AB
Posts: 1,376
Default

Quote:
Originally Posted by densa44 View Post
This lubricating business, some guys on here have never stuck a case, and I have broken a lee press like the one in the picture. Elk says to clean the die if you are getting dents, I am, I'll do that and see if that solves it.

I have the Lee trim parts but am unsure how to use the drill, or better yet a drill press. Do you just chuck the shell holder?

Again wonderful pictures and a great post.


Just like that...


And yes you should try cleaning your die, there is also a little relief hole in most dies that hides behind the lock ring that will expel excess lube... Unless its plugged up with dirt and gunk...

Sometimes some lubes will cause dents no matter how hard you try... I haven't had that issue with imperial wax yet... A little go's a long long way.
Reply With Quote