someone took the starter apart at some point in time and put the magnet back in wrong. Just did this to myself well working on a small quad. take the starter off and take apart try not to pull the shaft out from the output side as it can be a pain to get back together. take the middle section that holds the magnets and spin it around and put it back together. Bench test to see it should have switched directions spinning. Switch wires back and you are back to factory. Mine happened on a grizzly 125 which is the same as a breeze if that helps.
Last edited by 2fast4uRuss; 07-11-2018 at 11:41 PM.
|