Quote:
Originally Posted by Hogie135
So to me it looks like my cam is slightly leaning left. This tells me I need to take some twists out of the left yoke and add some to the right? Can I do this without a press? I watched a video of a guy using his hand to squeeze the down cable so he could insert a screwdriver in the cam to stop it going back to its rest position and he adjusted his yokes. I'm not sure if this is good idea or bad.
|
I would not use the screw driver method. Also, use your paper tuning results to adjust yokes as most bow will have some cam lean at rest. If your arrow is tearing right, then add twist to the right yoke and remove same amount from the left. Adding and removing equal amounts will keep the cam timing in sync.