35 Remington Reloading
Anyone out there reload 35 rem for marlin rifles. I have the newer Marlin 336 in 35 rem. The rifle shoots OK with the Hornady 200gr ftx bullets, but wanted to try the the Hornady 200 gr roundnose bullets. Loaded the bullets to the exact specs as in Hornady manual. Went to load the ammo into the rifle and found the handle doesn't close all the way to depress the trigger. I even seated the bullet lower and still the same problem. Anyone else encounter the same problem or is it the rifle or wrong bullet.
|
Quote:
|
Already tried that, closes just fine.
|
Your seating die is set wrong.
Run a trimmed and sized case up in your press, with the ram all the way up, with no die in the press. Loosen the lock ring on your seating die and slowly run it into your press and over the case on the press ram. You'll hit a point where you'll feel resistance as you screw the die in. Pull the ram on the press down, turn the die in 1/8 of a turn more and set the die's lock ring. Now back out the seating stem on the seating die about 3 turns. Slowly seat the bullet into a case and slowly. Back the ram on the press out and see how you are seating the bullet. Lower the seating stem till you get the bullet seated to the upper 3/4 of the cannalure on the bullet. You will now be seating your bullet with a light crimp. 200 gr round nose? Right? |
It is the 200 gr rn and I'm not new to reloading. I reload all my ammo, don't know why this giving me a problem. Even used new brass and also used a crimp die.
|
Quote:
A chamber casting may be in order . Stranger things have happened |
Quote:
35 Rem isn't the most robustly built casing out there, if your dies are a bit out of adjustment you could be distorting your brass ever so slightly. |
Quote:
|
Obviously this cartridge is a POS and you need to get rid of the rifle. I'll take it off your hands. Been looking for a 35 marlin for years. Congrats on finding one.
|
There is nothing wrong with the chamber, most likely. Always check the simplest stuff fist.
In all likely hood you are over crimping your bullets and the roll on the case is large enough to stop the case from fully chambering. Set your seating die to not crimp and run the rounds through. If they go, add only enough crimp to do the job and allow proper chambering. If the uncrimped cartridge won't chamber then you are set too far out and the bullet is contacting the lands. Seat them deeper into the case. |
Quote:
|
Quote:
|
.35 Rem
If you'd like to try one of your loads for chamber fit in my .35 R let me know, Im close to Airdrie.
|
Quote:
|
Great . Easy fix.
|
Quote:
|
Quote:
What make and model of crimp die? (Lee Collet taper crimp? or Lee Collet roll crimp? or Lee Factory solid crimp? other brand of solid taper crimp? or solid roll crimp? Were you seating and crimping in a single combined operation? Good Luck, YMMV. |
All times are GMT -6. The time now is 04:10 AM. |
Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.